How To Cut Paving Slabs

How To Cut Paving Slabs:

People cut paving slabs to cover the drain. Also, use it for steps or simply fitting pav to edge of the available area. It is a skill to cut the paving slab. You also need the right tools and little practice. You can reshape your paving slab as you want. Also, you can cut the slab with a hammer and chisel set. Here I will tell you how to cut paving slabs.

How To Cut Paving Slabs

Hamer and chisel:

It is a simple and old method to cut paving slabs. You can do this without using power tools. It only needs a little patient and one basic technique.

Use with:

  • Use for natural stone paving.
  • Also Indian stone paving.

Things you need:

  • A tape for measurement.
  • Also, need chalk or a pencil.
  • Also a hammer.
  • A breaker chisel.
  • Rubber mallet.

How to cut:

First of all measure the perimeter of the space that needs to fill with paving slabs with measurement tape. Draw the cuts with chalk on the paver slab you need. Here you will use a hammer and chisel to cut a shallow channel into a paver. You can split the slab with a rubber mallet when you scored the paver. If there are any uneven edges tidy up by chipping away the excess stone with a hammer and chisel. Your slab is ready.

Power saw:

You can use a power saw to cut the paving slabs. If you want to cut patio slabs with a power saw. You should keep in mind that they produce dust clouds and also can leave behind a lot of residues. so, you need safety glasses and a dust mask. It will be good for you to use dust suppression. When you spray water on the place of cut. The system will wash away the dust before it is airborne.

Use with:

  • You can use it for porcelain paving.
  • Also, granite paving.
  • Use it for the concrete paving slabs.

Things you need:

  • A tape for measurement.
  • You will use a pencil or chalk.
  • Also, a workbench.
  • It is better to use four C clamps to secure the slab is in place.
  • A power saw.
  • At the end a rubber mallet.

How to cut:

  • Use measurement tape with a pencil or chalk. Then measure the area where we will slot the paper and mark the cutting line on both sides of the paper.
  • Use C clamps to secure the paving slabs to the workbench. After this, the paver will not move.
  • Start your cutting through the paver and use the power saw. Follow the guidelines of marked lines. Cut one centimeter through one side then do this process to the other side.
  • Continous to cut all the way and then put this curved paver into place.

for more information visit this link

Howtofair.com

Add a Comment

Your email address will not be published. Required fields are marked *